System Operation
51 of 82
8
Press
Yes
next to “Is Flow OK?”. At this point the regeneration gas stops flowing. Step 1.
Heating begins. The Regen Status shows as Heating and the timer begin to count up. The
Regeneration Status is also shown on the Main Screen.
9
The system automatically progresses through the regeneration steps 1 to 5.
10
Upon completion of the solvent regeneration, open the column isolation valves (B & C), then
close the Solvent by-pass valve (A).
5.12 Analyzers
5.12.1 O2 Analyzer
When shipped, the oxygen analyzer valves are closed as shown i
below:
Figure 46 Oxygen analyzer valves – “Closed” position
WARNING:
The analyzer isolation valves should remain closed until the Glovebox has been
properly purged.
In order to monitor the oxygen content inside the Glovebox, the left Valve must be turned to the
“Flow Out” Position and the Right Valve must be turned to the “Flow In” position as shown in
below:
Figure 47 Oxygen analyzer valves – “Flow Out” position
136
