Replacing theEntireOvenMotor
2. Youmust drill 4 holes into the bottom of
the oven. Measure 15/16” from the center of
theovenmotor shaft oneach side, as shown in
the diagram at right, then 15/16” up from the
outer endof eachhorizontal segment. Or, you
can use the diagram as a template; just center
the bottommiddle circle over the ovenmotor
shaft. The picture below shows what the fan
motor looks likeunderneath thecolumnoven.
Ovenmotor shaft
GCMAINTENANCE
Replacing theColumnOvenFanMotor
1. Complete steps 1 and 2 on page 1.
3. Use a little oil on the drill bit because the oven is constructed of stainless steel. Drill 1/16” starter
holes in the center of each of the four corner circles. Gradually increase the drill bit size to 3/8”.
The following picture shows anSRI GC chassis in productionwith the fanmotor installed:
Ovenmotor shaft
4. Insert a flat blade scewdriver through each of the corner holes and loosen the screws holding the
oven fanmotor to the chassis.
