49 / 298
• 15 •
800-356-1688 •
www.restek.com2004 vol. 3
Restek Innovations Save
You Time and Money
Coo Too s !
Inlet Liner Removal Tool
• Easily remove liner from injector—no more burned fingers.
•Made from high-temperature silicone.
•Won’t chip or crack the liner.
No more burned
fingers!
Description
qty.
cat.#
price
Inlet Liner Removal Tool
3-pk.
20181
$25
ScoringWafer with Handle
•Unique, ergonomic handle is made of soft, comfortable rubber.
•Ceramic wafer cuts both fused silica and metal tubing cleanly.
Make clean, square
cuts!
Description
qty.
cat.#
price
Scoring Wafer with Handle
2-pk.
23015
$27
Septum Puller
•Many uses—keep several on hand.
•Use hooked end for removing septa and O-rings; pointed
end works well for removing stuck ferrules or fragments.
Description
qty.
cat.#
price
Septum Puller
ea.
20117
$13
Gently push the liner
removal tool onto the
liner in the injection
port, with a slight
circular motion.
Slowly pull the
liner out of the
injection port.
Place a new
liner in the
injection port,
avoiding hot
metal surfaces.
Hold tubing firmly in one
hand, allowing about two
inches to extend freely.
Hold the scoring wafer at
a 45° angle to the tubing.
Exert just enough pres-
sure to put a slight arc in
the tubing. Pull perpendic-
ularly across the tubing.
The tubing
should fall off
or break with
a slight tap of
the wafer.
Check the
cut against
the white of
the scoring
wafer. Look
for a clean,
square cut.
Remove septum without
damaging an expensive
weldment.
Dislodge a stuck ferrule
quickly and easily—with-
out scoring the fitting.
Easily remove septa
and ferrules!