ASSEMBLAGE of IKCOLUMNS
5.
Into theLower Lid, install (3/8”-16) threaded studs using 2hex nuts (A, B).
6.
Place theBarrel on theLower Lid so that the PackingPort is located between the studs,
7.
Place theUpper Lid so that the Inlet ports are located at the opposite sides of the columnperimeter, as shown.
8.
Tighten the lids together by holdingwrenches onnutsA andC, working around the column perimeter andgradually increasing the
force.
9.
To open the column, hold thewrenches on nutsB andC.
A
B
C
PackingPort Plug
To replace the tip, use the tip from a 3-ml
BD-syringe if needed
PackingPort Adopter
Adopter connects to femaleQuick-
Disconnect® fitting for slurry packing.
Use replacement O-rings #011 (5/16 x 7/16)
and #110O-ring: (3/8” x 9/16”), if needed.
