681
WASHERS
W
WG-2045/1060/4060/3060/4090 Optionals
Stainless steel bases and frames
B9040
B9040
Base for 90 cm wide models only.
The frame allows bringing the machine loading level up
to an ergonomic height approximately 70 cm from the
ground. Entirely made of stainless steel.
A detergent compartment with anti-drip bottom and front
door with push-pull opening is integrated in the base.
Dimensions I x d x h = 900x530x400mm.
B6040
(not shown in the photo): for 60 cm wide models
only. Dimensions I x d x h = 600x530x400mm.
B9040QWC
B9040QWC
Base with integrate demineralized water boiler. For 90 cm
wide models only. A boiler is housed in the base to preheat
the demineralized water to get fastest cycles
Dimensions: I x d x h = 900x530x400mm.
Frame for 90 cm wide models only.
The frame allows bringing the machine loading level up to
an ergonomic height approximately 70 cm from the
ground. The frame also facilitates cleaning the machine
underneath. Entirely made of stainless steel.
Dimensions I x d x h = 900x530x400mm
T6040
(not shown in the photo): frame for 60cm models
only. Dimensions I x p x h = 600x530x400cm.
WD-PRINT
External 24-
character impact
matrix printer with
real-time clock
function.
Complete with
thermal paper roll.
T9040
T9040
Traceability options
WG-2045 Configurations
This configuration has two washing levels with rotary sprays
where supports for all types of glassware can be located
(beakers, test tubes, flasks, plates & various other materials).
Photo:
D-CS1
upper rack: SB9 straight tine support for beakers &
flasks to the left, SB14 spring tine support to the right. Each
support occupies 0.5 the rack for machines with width of
45cm.
D-CS2
lower rack: SB28 universal spring support for beakers
& flasks, standard on 50-cm models, occupying all of the
lower base but cannot be positioned on the upper rack.
Two spraying levels
This configuration has two washing levels with rotary sprays
where supports for all types of glassware can be located
(beakers, test tubes, flasks, plates & various other materials).
Photo:
D-CS1
upper rack: the carriage is fitted with 2 racks
equipped with compartments (CP192 and CP222) to wash
test tubes.
D-CS2
lower rack: SB9 straight tine support for beakers &
flasks to the left, SB14 spring tine support to the right. Each
support occupies 0.5 the rack for machines with width of
45cm to optimize the load on the rack.
Two spraying levels
WD-PAPER
Thermal paper roll. Diameter 50 mm, width 57mm.
